Owner's manual

- 12 -
as a selection, it is highly recommended that you chose a specific
selection, to reduce the chance of incompatibility. Typically the
selections are as follows:
Areas Switch Types
Canada & United States Northern Telecom & NI-1
Japan INS Net 64
Taiwan DSS1 (ETSI)
Europe DSS1 (ETSI)
9. Enter the ISDN phone numbers and the Service Profile Identifier. Number
(SPID) will be supplied by your local ISDN telephone company.
[NOTE: With the
“INS Net 64”
&
"DSS1 (ETSI)”
switch types, there are no SPID’s to be entered.]
10. Now you are ready to connect the ISDN TA PC card to your system.
Refer to the Hardware Installation section for details.
Making Multilink PPP Connections
The Intelligent ISDN TA PC Card supports the combining of two 64 Kbps
data channels into the equivalent of a single 128 Kbps line, which is known as
Multi-Link connection. To make the multilink PPP connections, firstly the
PPP connection has to be completed, and the hardware (the ISDN TA PC
Card) has been properly installed. Perform the following steps to proceed.
1. Go to the
Start
menu. Point to
Program
. Select
Configuration Utility
.
Execute
CONFIG
.
2. Open “
General
” tab. Click “
MP Enabled
” in “
PPP Setting
”.
3. Apply the other settings, “
BOD Enabled
” and “
Second Phone No
.” if
available.
Making V.110 Connections
1. Execute “
Config
” in
Configuration Utility
.
2. Select the
COM Port Setting
tab. Select “
V.110
” for “
B-Channel
protocol
” in “
1
st
COM port setting
”.
3. Make sure
Dial-Up Networking
is well installed.
4. Double-click “
Make New Connection
”.