Owner's manual

- 42 -
Installing the Application Programs
Before you start, make sure the type of your Application Program Interface. The Application
Program Interface (API) is used as the interface between the hardware (ISDN TA PC Card) and the
application programs. Up to date, the available Application Program Interface for Windows NT are NDIS
and CAPI. Make sure the type of API matching your system. Move to the specific section titled the
appropriate API for your need for installation.
NDIS Mode
1. Insert the application software disk or compact disc into your computer.
2. Go to the
Start
menu. Click
Run
.
3. If you are using compact disc to install the application software, type in
the CD-ROM drive letter followed by
winnt\ntap\setup
. Or if you are
using disk, type in
a:setup
. The
Configuration Utility
installation
program will proceed automatically.
4. Follow the on-screen instruction to continue. When finished. Windows
will prompt you to restart your computer. Click
Finish
to restart your
computer.
5. For Windows NT does not support hot swap, remember to insert the PC
card in the PCMCIA socket of your computer while you are restarting
your computer.