Owner's manual

- 4 -
HARDWARE INSTALLATION
If you are using the ISDN TA PC Card under Windows 95/98/2000, Do NOT insert the PCMCIA card
until after the software installation is completed.
1. Align the PC card with the arrow sign pointing toward the computer’s
PCMCIA slot.
2. Connect the 15-pin PC card connectors with the two exposed end of the
PC card. Push evenly and steadily until the units ‘click’.
3. Connect the ISDN line to the opposite end of the ISDN Network
Connection Cable. Note: If your NT1 box does not have 100 ohm resistor,
then the 100
Ω
ΩΩ
Ω
terminator resistor (optional) is required and should be
used as a connector to connect the ISDN line with the ISDN Network
Connection Cable. Consult your dealer if the 100
Ω
terminator resistor is
not included in the package.