Owner's manual

- 6 -
FIRST THING TO KNOW ABOUT SOFTWARE INSTALLATION
The ISDN TA PC Card is designed to support a wide bandwidth of
interfaces/drivers for a total solution in different environments. The software
setup procedures accordingly vary from interfaces/drivers to interfaces/drivers.
To help you set up the software efficiently, the software installation is
organized by interfaces under
Windows 95/98/2000
and
Windows NT
respectively.
The following figures are illustrated as guideline-like flow charts. If something
goes wrong, track down the flow to check if there is any procedure missing
while setting up; and move to the corresponding section for details.
VCOMM Port
Hyper Terminal
CAPI 2.0
RVS-COM
NDIS Port
ISDN Low
Driver
DUN
CAPI NDISVCOMM
Interface
Center
Driver
Level Driver
* PPP
*
V.120
V.110
*
* PPP
* V.110
*
X.75
*
V.120
*
Modem
* Eurofile Transfer
* G3 FAX over ISDN
* PPP
Windows 95/98/2000
 The blocked area indicate that after when
setup.exe
has been executed
(see section titled “
Installing Device Driver
”), the Phone Dialer
VCOMM Port driver, CAPI 2.0 and the ISDN Low Level Driver were
also installed. You may then use Phone Dialer or the functions with
VCOMM directly.
 For CAPI mode, however, it is required to install RVS.COM Center
beforehand to enable the functions with CAPI.
 For NDIS mode, unless the NDIS Port Driver has been installed, the
ISDN Low level Driver won’t be able to work.