User's Guide
Table Of Contents
- TK-RP08
- The TK-RP08 allows its user to upgrade firmware contents whenever is needed to enhance its functionality and/or performance. With the firmware upgrade feature, your investment on the unit is further ensured and its life-time value just maximized. You don’t have to buy a newer unit just to have better features, instead you can have them all added to your current unit with an easy flash upgrade! The correct Flash upgrade procedure is described below. Please follow the instructions to complete your firmware upgrade.
- The TK-RP08 can be used as a power control accessory for TK-IP101 Swtich, or any other KVM Switch that supports a standard serial power control.
- Before you connect the TK-RP08 to the TK-IP101, you might need to install them first into their own proper placements within a rack, that is , if you are going to use them within a rack. After you have installed the TK-RP08, TK-IP101 into the rack, or into their proper locations, you can now proceed with following steps for further connections.
9
Step 8. After you have successfully upgraded the flash
firmware and before you utilize the TK-RP08 Unit,
you should perform a system reset by powering
down the unit. Wait for a few seconds and then
complete the reset again.
Troubleshooting
If the flash upgrade procedure seems never ending or you
see the following message:
Please send new firmware
, shown on
the screen, it indicates that the flash process had failed. If that is
the case, please power off the TK-RP08 Unit and then power it
on restart the whole flash procedure again. You also press any
button on front panel about 3 seconds when you power on the
TK-RP08 Unit.