User Guide

TRENDnet User’s Guide

PoE Web Smart Switch Series

System

System Management

Set your system information

System > System Management

This section explains how to assign a name, location, and contact information for the

switch. This information helps in identifying each specific switch among other switches

in the same local area network. Entering this information is optional.

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on System, and click on System Management.

3. Review the settings. When you have completed making changes, click Apply to save

the settings.

• System Description - Specifies the Switch model. You cannot change this

parameter.

• System Object ID - Indicates the unique SNMP MIB object identifier that

identifies the switch model. You cannot change this parameter.

• System Name - Specifies a name for the switch, the name is optional and may

contain up to 15 characters.

• System Location - Specifies the location of the switch. The location is optional

and may contain up to 30 characters.

• System Contact - Specifies the name of the network administrator responsible

for managing the switch. This contact name is optional and may contain up to

30 characters.

4. Click Apply.

5. At the bottom of the left hand panel, click Save.

6. Select the Config you would like to save the settings to, then click Save Settings to

Flash,.

Note: This step saves all configuration changes to the NV-RAM to ensure that if the

switch is rebooted or power cycled, the configuration changes will still be applied.