User Guide

TRENDnet User’s Guide

PoE Web Smart Switch Series

Click Add to add the entry to the table.

In the list, you can click Modify to modify an entry or click Delete or delete the entry.

You can also click Delete All to delete all of the entries in the table. If the entries span

multiple pages, you can navigate page number in the Page field and click Go or you can

click First, Previous, Next, and Last Page to navigate the pages.

5. At the bottom of the left hand panel, click Save.

6. Select the Config you would like to save the settings to, click Save Settings to Flash,

then click OK.

Events

System > RMON > Event

An event specifies the action of the switch when the ingress packet activity on a port

crosses a statistical threshold defined in an alarm. The choices are to log a message in

the event log of the switch, send an SNMP trap to an SNMP workstation, or both. Since

there are only three possible actions and since events can be used with more than one

alarm, you probably will not create more than three events - one for each of the three

actions.

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on System, click on RMON, and click on Event.

3. Review the settings.

• Index: This parameter specifies the ID number of the new group. The range is 1

to 65535.

• Description: This parameter specifies a text description of the event that you

are configuring.

• Type: This parameter specifies where to log the event when it occurs. The

choices are to log a message in the event log of the Switch, send an SNMP trap

to the SNMP NMS software, or both.

• Community: This parameter specifies the community where you want to send

the SNMP trap.

• Owner: This parameter is used to identify the person who created an entry. It is

primarily intended for switches that are managed by more than one person,

and is an optional field.