User's Guide
Table Of Contents
- Product Overview
- Switch Installation
- Access your switch management page
- Saving configuration and switch between web modes
- Surveillance Mode Web Interface
- Standard Mode Web Interface
- Status
- Network
- Port
- ONVIF
- PoE (Power over Ethernet)
- VLAN
- Voice VLAN
- MAC VLAN
- Surveillance VLAN
- MAC Address Table
- Spanning Tree (STP, RSTP, MSTP)
- LLDP (Link-Layer Discovery Protocol)
- Multicast
- Configure unknown multicast and multicast forwarding method
- Add static multicast group addresses
- Add multicast router ports
- Configure IGMP snooping settings
- Configure IGMP snooping settings for IPv4 multicast traffic.
- Configure multicast querier settings
- View IGMP snooping statistics
- Configure MLD snooping settings
- Configure MLD snooping settings for IPv6 multicast traffic.
- View MLD snooping statistics
- Configure MVR settings
- Configure MVR port settings
- Configure MVR Group Address Table
- Security
- Configure RADIUS settings
- Configure RADIUS network authentication settings
- Configure RADIUS network port settings
- View authenticated sessions
- Configure Management Access
- Configure Management ACL/ACE (Access Control Lists/Access Control Entries)
- Create new access control list
- Configure Port Security
- Configure Protected Ports
- Configure Storm Control
- Denial of Service (DoS)
- DHCP Snooping
- View DHCP Snooping Statistics
- Configure DHCP Option 82 settings
- Configure DHCP Option 82 Circuit ID settings
- Configure IP Source Guard
- Configure IP Source Guard IMPV Binding
- Save DHCP Snooping Database
- ACL
- QoS
- Diagnostics
- Management
- Modify admin password and create new users
- Upgrade switch firmware
- Backup/Restore switch Configuration
- Save switch configuration to NV-RAM / Restore to default
- SNMP
- Configure the SNMP View Table
- Configure the SNMP Group Table
- Configure the SNMP Community Table
- Configure the SNMP Users
- Set the SNMP Engine ID
- Configure the SNMP Trap Management
- Configure the SNMP Notification
- RMON
- View RMON Statstics
- Configure RMON History Table
- Configure RMON Event Table
- Configure RMON Alarm Table
- Create Schedules
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-3012LS / TPE-3018LS
14
Overview
Overview
The overview page will provide a display of the front panel and icons representing
connected devices or links. Additinally, this page will display specifically if IP cameras are
connected or other links and also display the data link speed the devices are connected.
PoE can also be enabled or displayed on each port.
1. Log into your switch management page (see “Access your switch management page”
on page 11).
2. Click on TPE-3012LS or TPE-3018LS (depending on the switch model) in the top left
and click the Overview tab.
Note: The switch will scan for connected device every 30 seconds. Additionally, the green
colored ports on the front indicate which ports are PoE and blue which ports are data
ports only.
Port Number
Amber: 10/100Mbps
Green: Gigabit
PoE On/Off Button: Click
the port PoE button to
turn PoE on or off.
On Off
Icons will indicate
whether the device is an
IP camera or other.