Quick Installation Guide TPL-401E TPL-401E2K 1.
Table of Contents English 1. Before You Start 2. How to Install 3. LEDs and Buttons 1 1 2 5 Troubleshooting 6 Version 10.19.
1. Before You Start Package Contents TPL-401E/TPL-401E2K ? ? CD-ROM (Utility and User's Guide) ? Multi-Language Quick Installation Guide ? Cat.5 Ethernet Network Cable (1.5m/5ft) System Requirements CD-ROM drive ? ? A Desktop or Laptop PC with Network Adapter Installed ? Existing 10/100Mbps wired network when TPL-401E is used as a bridge device ? Additional 200Mbps HomePlug ® AV or IEEE 1901 compliant powerline adapter (e.g.
2. How to Install Powerline Networking Solution 500Mbps Powerline AV Adapter Kit (TPL-401E) Internet Gigabit Powerline The example diagram shows a typical powerline network configuration in a home environment with 3 powerline adapters installed in different rooms. The orange line represents the powerline connectivity established through your home's electrical system and the blue lines represent Cat.
Below is an example showing how to create a Powerline network using the TPL-401E and your existing router to share Internet. 1. Plug a TPL-401E into an available power outlet. This TPL-401E should be located within the reach of the router's network cable. Outlet 2. Connect a network cable from the TPL-401E to an available LAN network port on your router (e.g. TEW-673GRU). 3. Plug a second TPL-401E into an available power outlet where your remote computer or network appliances (e.g.
4. Connect a network cable from the TPL-401E network port into the network port on your remote computer or network appliance (e.g. Game Console, Blu-ray player, IP Set box, network enabled TV, etc.). Outlet 5. Verify that the PWR (Power), PL (Powerline) and ETH (Ethernet Link/ACT) LEDs are on for both TPL-401E adapters.
3. LEDs and Buttons PWR (Power) ETH (Ethernet Link/ACT) PL (Powerline) The Gigabit Ethernet/Network Port and Reset buttton are located at the bottom of the device. Gigabit + Ethernet / Network Port Reset Button Sync Note: Please refer to the User's Guide on the TPL-401E/TPL-401E2K's User's Guide CD for detailed explanations of each LED and button.
Troubleshooting 1. I have verified that my Powerline device is connected to my workstation, but I cannot detect other Powerline devices. What should I do? 1.Verify that you are using Cat. 5, Cat. 5e or Cat. 6 Ethernet network cables for each TPL-401E adapter. 2.Verify that the power outlet of the TPL-401E adapter is plugged into is on the same electrical system and/or circuit breaker box. 3.
Windows Vista 1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Manage Network Connections and then right-click the Local Area Connection icon and then click Properties. 2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address automatically. Windows XP/2000 1. Go into the Control Panel, double-click the Network Connections icon and then right-click the Local Area Connection icon and then click Properties.
Description of Modes Erp (EuP) Operation: Standby Mode The EUT has no external mechanical switch and uses an internal program to control active and standby modes. Disconnect the Ethernet cables from the device Ethernet ports, and after 3 minutes, the device will enter standby mode. The Power (PWR) LED will flash every 15 seconds to indicate that the device is currently in standby mode.
Copyright ©2010. All Rights Reserved. TRENDnet.
