User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Application Diagram
- Diagram Explanation:
- Installing Your Powerline Adapter
- Powerline Security
- Scramble your Network Name Away from the Factory Default
- Before Physical Installation
- Connecting the Powerline Adapters
- Connecting Additional Powerline Adapters
- Physical Installation
- Create Multiple Powerline Networks
- Move Powerline adapters between different overlapping powerline networks
- The Powerline Utility
- Powerline Utility – Map View
- Auto Scan
- Remote Devices
- Local Device
- Manage your device
- Rename
- Enter Password
- Add Device
- Scan
- Network Type
- Powerline Utility – Detailed View
- Show Active Device(s) Only
- Delete
- Add Device
- Save Report
- Remote Devices
- System Information
- Manage your report
- Powerline Utility – Device Setup
- Use Default
- Private Network Name
- Multicast Address
- Set Remote Devices
- Set Local Device
- Powerline Utility – Advanced
- Select Local Device
- Factory Defaults
- Reset Device
- Upgrade Firmware
- Powerline Utility – Options
- Scan Options
- Powerline Utility – About
- About Powerline Utility
- Regulations
- Limited Warranty
TRENDnet User’s Guide TPL-421E/TPL-421E2K
© Copyright 2015 TRENDnet. All Rights Reserved. 14
Move Powerline adapters between different
overlapping powerline networks
Note: Assuming all Powerline adapters are TRENDnet Powerline adapters and for
reference in the diagram and this procedure, the adapters will be labeled Adapter
A, B, C, D, and E. Adapters A, B, and C are currently connect together to form one
Powerline network and adapters D and E form another Powerline network. Adapter
B will be disconnected from adapters A and C and connected to adapters D and E.
1. Push and hold the Reset button on adapter B for 1 second and
release it. All LEDs will turn off and turn back on. This will make
adapter B settings to factory default.
2. Push and hold the Sync button on adapter D for 2 seconds and
release it. The Power LED will start blinking.
3. Within 2 minutes, push and hold the Sync button on adapter B for 2
seconds and release it. The Power LED will start blinking. This will
establish connectivity between adapter B, adapter D, and adapter E
by reconfiguring the network name of adapter B to match the
network name of adapter D and adapter E. All LEDs will turn off and
turn back on and the Powerline LED will turn on the when adapters
are connected.