Webcam User Manual

Note:

The TV-IP410WN will not work wirelessly until you disconnect the Ethernet cable from

the back of the camera.

12. Click Setup, Network and then click Wireless.

14. Disconnect the RJ-45 cable and unplug the

power. Then plug the power back in.

15. Verify the Power (Amber) and Link

(Green/Blinking) LEDs are on.

13. Click Site Survey. Select an ESSID. The

ESSID (SSID) is the wireless network name

for your wireless network (e.g. wireless router

or access point). If encryption is enabled,

select the proper Authentication and

Encryption type, enter the Pre-Shared Key

and then click Apply. (Example shows

WPA2-PSK. If your wireless network does not

support WPA, select open or shared instead.

Contact your network administrator for more

information).