User's Guide
Table Of Contents
- About this User’s Guide
- Before you start
- Packing List
- System Requirements
- Default Settings
- Introduction
- Camera Hardware Components
- Camera Hardware Components
- Hardware Installation
- Camera Applications
- Security
- Software - Setup Wizard
- Browser Configuration
- Accessing the Camera Video Display
- Login
- Web Manager and Live Video Display Page
- Administration - Status Section
- System Page
- Video
- Audio
- Wireless
- Network
- Active Users
- Configuration Section
- System
- Video
- Audio
- Wireless
- Network
- User
- Upload
- Tools Section
- FTP Server Test
- E-Mail Test
- Restart
- Factory Reset
- Firmware Upgrade
- Backup and Restore
- Software – IPViewPro 2.0
- Launching IPViewPro 2.0 for the first time
- Add a camera for monitoring
- Display Controls
- Snapshot, recording and audio controls
- Live video display controls
- Camera configuration with IPViewPro
- Schedule Recording with IPViewPro 2.0
- Motion Detection and Digital Input
- IPViewPro Miscellaneous Options
- Load Saved Video Files
- Technical Specifications
- Limited Warranty
TV-IP501W Internet Camera User Manual
5
System Requirements
Computer
CPU: For Intel x86 compatible CPUs: Intel Pentium IV 2.0Ghz or above
CPU: For IA64 compatible CPUs: AMD Athlon 64 3000+ and above
Memory: 1GB or above
VGA Resolution: 1024 x 768 or above (Independent Display Card recommended)
10BASE-T Ethernet or 100BASE-TX Fast Ethernet Network Interface Card
CD-ROM Drive for Setup Wizard on Installation CD-ROM
IPViewPro 2.0 Application Users must use Microsoft® Windows®2000, XP or Vista Operating
System with Internet Explorer 6.0 or above with DirectX9.0
Network
Local Area Network: 10Base-T Ethernet or 100Base-TX Fast Ethernet
Wireless: 802.11b/g wireless adapter
Note: When you connect multiple cameras and monitor their images synchronously, it is
recommended to use a high performance system, such as a Pentium 4 & 2.4GHz PC
Default Settings
Default configuration settings
Username This is the Username you will be prompted to enter when you access the
camera configuration screens using a Web browser. The default Username is
admin.
Password This is the Password you will be prompted to enter when you access the
configuration windows using a Web browser. The default Password is admin.
IP address This is the IP address you will enter into the Address field of your Web browser
to access the camera monitor screen and configuration menus using a Web
Browser. The camera uses DHCP for IP settings by default. If a DHCP server is
not detected, the default IP address is 192.168.10.30. (Make sure your
computer is configured to belong to the 192.168.10.X subnet if using the default
IP address of the camera.)
Subnet Mask The default subnet mask is 255.255.255.0