User's Guide

TV-IP512WN Wireless N Internet Camera Server with 2-way Audio
13
Reset Camera
A manual reset can be conducted by following the procedure below. The reset button is located on
the rear panel of the camera. To reset the system settings to factory defaults, please follow these
steps:
1. Leave the camera powered on, do not disconnect the power.
2. Use a paper clip or similar object to press the reset button and hold. The reset button is
located on the rear panel of the device. See the Rear Panel Components picture above to
locate the reset button.
3. Keep the button pressed about 10 seconds.
4. Release the button.
The camera will then automatically reboot itself. Upon restarting the camera loads the factory
default configuration settings. The default IP address 192.168.10.30 and subnet mask
255.255.255.0 will be applied unless a DHCP server is actively connected to the network. The
administrator’s default user name is admin and the password is admin. Use the Setup Wizard
shipped with the camera to reconfigure it or access it through the web-based management
software.
WPS Button
Use the WPS button for quick and easy wireless LAN connection configuration.
WPS Button
Use this for fast configuration of wireless connection.
Push WPS button for over 3 seconds and the LED will blink 0.5 time/ sec.
- Success: LED will light and then reboot directly.
- Fail: LED will blink 0.1 times a second for 10 seconds and then reboot directly.
WPS
button