Quick Start Guide

7. After I successfully configured the TV-IP602W to match my wireless network settings, I

can not connect to the camera.

1. Verify that the wireless settings match your wireless network settings.

2. Verify in the wireless section of the browser configuration that the Enable Wireless option

is checked.

3. Make sure to disconnect the Ethernet cable from the camera and verify that the

LINK LED is blinking red.

4. Please refer to the Wireless tips section if you continue to have wireless connectivity

problems.

8. I forgot my password. What should I do?

Take a pin or paperclip and press the reset button on the back of the unit for 15 seconds.

This will return settings back to factory defaults. Open up the SetupWizard program to find

out the IP address of the camera (see step 11 in Section 2: Hardware Installation and

Configuration. If you do not have a DHCP server on your network, the default IP address is

192.168.10.30. The default administrator ID and password is admin.

If you still encounter problems or have any questions regarding the TV-IP602WN, please contact

TRENDnet's Technical Support Department.