User's Guide

TRENDnet User’s Guide

TV-IP751WC/ TV-IP751WIC

Restart

If you should need to restart the IP camera, you can do this from this screen.

Clicking Yes will initiate a reboot sequence on the camera. When you restart the

camera you will lose your connection to it. Wait 1 minute before attempting to

reconnect to the camera so that it has time to go through its boot up sequence.

Restarting the camera will retain the configuration settings you have entered.

Factory Reset

If you should need to restore the camera to the factory settings, you can do it from this

screen. Clicking Yes will initiate a reboot sequence on the camera. When the camera

restarts, you will lose your connection to it. The username and password will also both

be set back to the default admin. Wait 1 minute before attempting to reconnect to the

camera so that it has time to go through its boot up sequence.

Note: Factory reset will erase the current configuration settings on the camera. You

should back up the settings first if you wish to keep them. See the Backup and Restore

section for more information.

Firmware Upgrade

Click the Browse button and locate the firmware file you saved on your computer

and choose Open. When you are ready, click the Upgrade button to begin the

firmware upgrade.

Note: Upgrading the firmware is a sensitive process. Be sure that you have the

correct firmware for your model of camera and do not disconnect the power during

the upgrade process.