Quick Installation Guide

6
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may cause undesired
operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Troubleshooting
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
My computer does not detect the TVP-SP2. What should I do?
First, make sure your computer meets the minimum requirements as specified in Section
1 of this Quick Installation Guide. Second, make sure the USB cable is physically plugged in
as described in Section 2. Third, try installing the TVP-SP2 to a different USB port of your
computer.
I am unable to make a call. What should I do?
First, make sure that you have Internet connectivity. Second, make sure that you have
signed into your Skype™ account. Third, make sure that you see the TVP-SP2 software
icon located on the system tray . If you do not see this icon, go to Start -> Program
Files -> TRENDnet -> TVP-SP2. Fourth, make sure that you have followed the exact steps
in section 3 of this Quick Installation Guide.
The speaker/microphone function does not work. What should I do?
First, make sure that you have installed the TVP-SP2 software program as described in
Section 2. Second, right click on the TVP-SP2 software Icon located on the system tray
and select Audio Device Settings. Make sure speaker and microphone are set to USB
Audio Device. Third, right click on the TVP-SP2 software icon and select Volume Control.
Make sure the volume is set appropriately for the microphone and speaker. Fourth, if you
see the microphone icon on the LCD screen, press on the microphone button on the
TVP-SP2 keypad.
How do I switch back to my computer's original audio settings?
Right click on the TVP-SP2 software icon located on the system tray and select
Audio Device Settings. Select the desired Windows Default Audio Device for the
speaker and microphone. Then click OK.
If you still encounter problems or have any questions regarding the TVP-SP2, please refer to the
User's Guide included on the Utility & Driver CD-ROM or contact TRENDnet's Technical Support
Department.