Warranty

SOLAR LIGHTS

CARE AND USE INSTRUCTIONS

IMPORTANT NOTES:

Remove protective film from solar panels. To allow each battery to reach full

capacity, pull out the plastic tab and place in full sunlight for the first 12 hours.

Failure to do so can shorten the life of the battery or operation of the light.

To protect the glass from damage, do not use force during assembly. Keep the

glass in the packaging until you need to install it.

GROUND STAKES

Pre-drill a hole into the ground using a screwdriver. Do not make the hole larger than

the ground stake. Insert assembled solar light into the pre-made hole. Do NOT use a

hammer on the ground stakes as you could damage the item.

BATTERY INFORMATION

INSTALLATION / REPLACEMENT INSTRUCTIONS

1. Twist off the top of solar head from the cage.

2. Slide the power switch to the “OFF” position.

3. Access the battery compartment and unscrewing it using a Phillips head

screwdriver.

4. Remove old battery and replace with new AA NiMh 450 mAh rechargeable

battery. Do not use a smaller mAh battery as it will affect performance. Larger

mAh batteries are acceptable.

5. Ensure you have positioned the battery with the correct polarity (+) and (-).

6. Replace battery cover and re-insert the screws on the battery compartment.

7. Slide the power switch to the “ON” position and allow new battery to fully charge

prior to first use.

8. Batteries must be recycled or disposed of properly.

BATTERY WARNINGS

 Do not use alkaline, standard (carbon-zinc) or NiCd (nickel cadmium)

batteries in our solar lights.

 Only use NiMh rechargeable batteries (product include 2 NiMh rechargeable

battery)

 Do not mix battery types. Only use NiMh battery(s).

 Battery performance is affected by weather and temperature.