Installation & Assembly

TOOLS REQUIRED

CAUTION

Assembly Instructions

Wire

strippers

Ladder

Safety

glasses

Electrical

tape

Phillips

screwdriver

PliersFlat blade

screwdriver

• Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect in

the wire, do not attempt installation.

• Before starting installation of this ﬁxture or

removal of a previous ﬁxture, disconnect the

power by turning o the circuit breaker or by

removing the fuse at the fuse box.

page 1

Fixture

Mounting Unit Mounting Screws Wire Nuts

Chain Canopy Screw Collar Ring

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

CHANDELIER LIGHT (CHAIN)

PAGE 1
CHANDELIER LIGHT (CHAIN) Assembly Instructions CAUTION • Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. • Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
CHANDELIER LIGHT (CHAIN) Assembly Instructions STEP 1 Attach the end of the chain to the loop on the fixture. STEP 2 Use the mounting screws to attach the mounting unit to the junction box STEP 3 Pass the chain and the branchwires through the screw collar ring and canopy. Feed the branchwires through the pipe nipple on the mounting unit and attach the end of the chain to the mounting unit.
PAGE 3
CHANDELIER LIGHT (CHAIN) Assembly Instructions Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round & smooth) or Black Fixture Wire to: Black or Red Supply Wire or Insulated Wire (other than green) with copper conductor. STEP 4 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts.