Assembly Instruction

ASSEMBLY INSTRUCTION
NOTE: Please consult a qualified electrician if you are not certain of installation or servicing.
CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by
removing the fuse at the fuse box.
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Attach Mounting Strap to Outlet Box using the provided outlet box screws.
3. Fasten Rod A onto the Nipple, Rod B onto Rod A, Decorative Part onto Rod B, Rod C onto Decorative
Part and Rod D onto Rod C. Weave fixture wires up through the Canopy. Hang Hook to Loop.
4. Connect the wires with writing on it from fixture to the black wire from the supply circuit. Connect the
wire without writing on it (with raised ribs) from fixture to the white wire from the supply circuit. Cover
the connections using provided Wire Connectors. Tie the ground wire from fixture and from Outlet Box to
the Ground Screw on the Mounting Strap. Position wires back inside Outlet Box.
5. Place the Canopy to Outlet Box by aligning the protruding Mounting Screws all the way through the
Canopy holes and thread 2 lock nuts to Mounting Screws until the Canopy is held firmly against ceiling.
6. Unscrew Socket Ring from Socket. Place Shade over Socket and reattach the Socket Ring to Socket until
the Shade is held firmly to the fixture. Install the Bulb. (Not included).
7. Turn on power.