Installation & Assembly

8
USE PART 7
TO TIGHTEN
PART 8 INTO
WALL STUD
[x4]
7
4
FROM STEP 3
8
IMPORTANT: FAILURE TO PROPERLY SECURE UNIT TO WALL
AS SHOWN MAY RESULT IN INJURY.
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL LINING AT LEAST ONE SIDE UP WITH A STUD.
2.
LIGHTLY MARK YOUR WALL USING A PENCIL IN EACH MOUNTING HOLE ON THE FLANGES.
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR MARKED SPOTS USING A
3
16
" DRILL BIT.
IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 9). DRILL
5
16
" HOLE AND HAMMER
ANCHOR INTO PLACE.
4. PLACE UNIT BACK ON WALL AND INSERT SCREWS (ITEM 8) INTO FLANGES & TIGHTEN USING ITEM 7.
DO NOT OVER TORQUE.