UNIT WEIGHT: 18in (10 lbs) 24in (12lbs) 30in (16 lbs) WEIGHT CAPACITY PER SHELF/TIER: 10 LB INDUSTRIAL WALL MOUNTED ETAGERE RACK
Fastening System Each design utilizes a simple & effective fastening system to quickly assemble your unit. To reduce assembly time, each fitting (connector) has pre-installed set screws (spare set screws are provided) at EACH pipe entry location. Set screws are tightened using a 1/8” Allen Key, which safely secures the pipe in place.
10.00" 18", 24", or 30" 10.77" 12.00" 12.00" 10.19" 38.81" 0.81" 15.00" VARIES* 13.4", 19.4", 25.
DISCLAIMER: We intend to make this instruction manual accurate and complete. However, we make no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind.
[x1] Bottom Crossmember Assembly [x3] Shelf 2 1 [x2] Shelf Support Assembly [x1] Left Top Shelf Support Assembly 4 3 [x1] Right Top Shelf Support Assembly 5 [x1] 1/4" Allen Key Large Key [x1] 1/8" Allen Key Small Key [x4] Ø8mm X 40mm Screws 6 7 8 [x4] Plastic Wall Anchors 9 NOTE: SMALL ADJUSTMENTS MAY BE NEEDED ON SUBASSEMBLIES DUE TO SHIPPING MOVEMENT 5
1 1 3 2 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] 2 1 3 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] FROM STEP 1 MAKE SURE TO TIGHTEN ALL AREAS! Note: For Ease of Assembly, assemble laying down as shown. Protect floor from being scratched by pipe. Pictures are for reference.
3 4 5 FROM STEP 2 USE PART 6 TO TIGHTEN ALL NEW CONNECTIONS [x2] WARNING: FAILURE TO SECURE UNIT TO WALL AS SHOWN MAY RESULT IN SERIOUS INJURY 7
4 1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL LINING AT LEAST ONE SIDE UP WITH A STUD. 2. LIGHTLY MARK YOUR WALL USING A PENCIL IN EACH MOUNTING HOLE ON THE FLANGES. 3 3. REMOVE UNIT FROM WALL AND PREDRILL YOUR MARKED SPOTS USING A " DRILL BIT. 16 5 IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 9). DRILL " HOLE AND HAMMER 16 ANCHOR INTO PLACE. 4. PLACE UNIT BACK ON WALL AND INSERT SCREWS (ITEM 8) INTO FLANGES & TIGHTEN USING ITEM 7. DO NOT OVER TORQUE.
WARRANTY Finishes of Pipes and Fittings, and all Other Parts and Components, Excluding Wood -1 Year Limited Warranty- All metal finishes and other parts and components, excluding wood, are warranted to you, the original retail purchaser, for a one-year period starting from the date of purchase, to be free from material manufacturing defects.
