Assembly Instruction Sheet

ManualsBrandsTrent Austin Design ManualsCeiling LightsEden 3-Light Kitchen Island Linear Pendant

Package Contents

Warnings and Cautions

1of3

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject

glass parts to any shock while in operation or shattering may result.

Steel Collar

6” Rod

Fixture Loop

Shade

12” Rod

Upper Collar

Harp with

Socket Collar

Flat Washer

Rubber Washer

Diffuser

Small Flat

Washer

Finial

STEP 1 Attach Caps to Socket

Assembly

A. Attach the Caps (P/Q) to the ends of the

Socket Assembly (R) and secure with the

Lock Screws (O). Hand tighten until snug.

Figure 1

Lock Screw

Cap A

Cap B

Socket

Assembly

Hardware Contents

Crossbar

Assembly

Ceiling

Canopy

Fixture Chain

Quick Link

STEP 2 Assemble the Rods and the Fixture Loop-

A. Determine the Rods (B/C) to be assembled to the Socket Assembly

(R) according to your hanging height.

B. Pass the supply wires and ground wire through the chosen rods

(B/C) and the Fixture Loop (A). Thread the Socket Assembly (R),

the chosen Rods (B/C) and the Fixture Loop (A) together. Hand

tighten until snug.

Figure 2

Supply Wires

and Ground Wire

Nipple

Hex Nut

ToolsRequired:Flathead screwdriver,Phillips screwdriver,pliers, wirecutters, wirestrippers, electricaltape, safetyglasses.

EstimatedAssemblyTime:30-45minutes

Preparation:Identify andinspect allparts beforebeginning installation.Check packagecontent listand diagramsbelow tobe sureall partsare

present.If anyparts aremissing ordamaged, donot attemptto assemble,install, oroperate thefixture. Contactcustomer service for replacement

parts.

LightSource: (3)Medium Base100W bulbsMaximum,Alternatebulb(3) 23WCFLMaximum.

Thank you for purchasing a our product.

Need assistance with parts or assembly? Call our customer service or visit us on-line

Assembly Instruction

Sheet

Summary of content (3 pages)

PAGE 1
Assembly Instruction Sheet Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (3) Medium Base 100W bulbs Maximum, Alternate bulb (3) 23W CFL Maximum. Estimated Assembly Time: 30-45 minutes Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are present.
PAGE 2
STEP 7 - Install Ceiling Canopy BB Ceiling A. Attach the Lock Washer, the Ceiling Loop Canopy (BB) and the Covers over the DD end of the Nipple as shown. Secure by threading the Finial onto the Nipple. Hand tighten until snug. CC STEP 3 - Install Fixture Chains A. Adjust the Fixture Chain (CC) to your desired length by removing the links if needed. * Pliers is required for this step. B.
PAGE 3