Installation & Assembly

Step 8
å
Position the BACK (G) over your unit.
å
Make equal margins along the top and bottom edges of the BACK (G).
Push on opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (G) to your unit using the NAILS (LL).
å
NOTE: Perforations have been provided for access through the BACK.
Carefully cut out the holes needed.
å
Turn two CORD CLIPS (X) into the SMALL BACK (F).
å
NOTE: The CORD CLIPS are used to hold your cord against the BACK.
Page 12
Unfi nished
surface
G
X
F
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(22 used in this step)
LL