Installation & Instructions

ASSEMBLING THE FIXTURE (FIG. 1)
1. Shut off the power supply at the fuse box or circuit breaker. If
necessary, remove the old fixture from ceiling including the
mounting hardware.
2. Carefhat all parts are included as shown in the illustration.
3. Using China connects the loops (F) on bottom of canopy and
top of fixture housing.
4. Install the bulbs in accordance with the fixture’s specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
MOUNTING THE FIXTURE (Fig. 1)
5. Attach the mounting bar (A) to the outlet box using the outlet
box screws (C). The side of the cross bar marked “GND” must
face out.
6. Attach the fixture body onto the mounting bar (A) by
protruding center on nipple (B) through the mounting holes of
the canopy (D) and secure with loop (E).
CONNECTING THE WIRES (Fig. 2)
1. At this point, connect the electrical wires as shown in figure 2,
making sure that all wire connectors are secured. If your
outlet box has a ground wire (green or bare copper), connect
the ground wire from the fixture to it. Otherwise, connect the
fixture’s ground wire directly to the cross bar using the green
screw provided.
2. After wires are connected, tuck them carefully into the ceiling
junction box.
Your installation is now complete. Return power to the outlet
box and test the fixture.
Fig.1
Mounting plate
Ground Screw
Mounting Screw(2)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
INSTALLATION INSTRUCTIONS FOR FIXTURE