Assembly Instructions
ASSEMBLY INSTRUCTIONS
Carefully unpack all lamp parts from the carton.
1.Take the lamp carefully out of the Carton,and place it on a flat surface.
2. Be sure the power to the installation point is power off
3.Fasten the Crossbar to the outlet box . Locate the Nipple and thread into the center of the Crossbar.
4.Locate the Fixture Chain
、
Ceiling Canopy
、
Canopy Chain Loop
、
and Canopy Lock ring. Pass the
Fixture Supply Wire and Ground Wires through in the following order: 1)Alternate Fixture Loops in
the Fixture Chain; 2)Canopy Lock ring; 3)Canopy Chain Loop; 4)Ceiling Canopy.
Finally,proceed to pass the wires through the Nipple attached to the Crossbar.
5.Thread the BT58 Edison Bulb (Included) onto the Socket. Hand tighten until snug