Installation Guide

Package Contents
Warnings and Cautions
1of2
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
(3)A19MediumBaseVintageBulbs100WMaximum,bulbsincluded.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
LightSource:
EstimatedAssembly Time:
Preparation:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
C
B
Fixture Body
x1
Lock Screw
x3
D
Glass Shade
x1
E
STEP 2 Test Fitting
Ceiling Canopy to
Crossbar Assembly
-
A. Remove mounting balls
from the Crossbar
Assembly (A). Fit the
ceiling canopy and Fixture
Body (C) to the Crossbar
Assembly (A) and secure
with mounting balls. Note:
The ceiling canopy should
Mounting
Screw
Hex Nut and
Lock Washer
A
Mounting Ball
Figure 2
Figure 1
STEP 1 - Installing the Crossbar Assembly
A. Pass the supply wires from outlet box through the Crossbar
Assembly (A). Attach the Crossbar Assembly (A) to the Outlet Box
with the head of the Green Ground Screw facing you. Secure the
Crossbar Assembly (A) with Outlet Box Screws (not included).
Tighten until snug.
(Step 2 Continued)
be snug against the ceiling and the mounting balls. If not, adjust the
length of the nipple on the Crossbar Assembly (A) by unscrewing the
preassembled hex nut and lock washer and then screwing the
mounting screws in or out of the crossbar until the correct length is
achieved. Once the ceiling canopy and Fixture Body (C) is secure,
remove the mounting ball and Fixture Body (C).
C
Figure 4
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3
STEP 4 - Install Fixture to Ceiling
A. Carefully tuck all wires into the outlet box and position the ceiling
canopy over the outlet box. Align the holes in the ceiling canopy with
the mounting screws, then attach the ceiling canopy using the
previously removed mounting balls. Hand tighten until snug.
Vintage Bulb
x3
Mounting Screw
A
Mounting Ball
C
A
Crossbar
Assembly
x1
Outlet Box Screws
(not included)
A
Outlet Box
Supply Wires with
Ground Wire
Installation Guide