Instructions / Assembly

10/1/2012

STEP 1:

Check and Prepare Rough Opening for the installation of door unit.

 Measure rough opening to confirm the rough opening

is the correct size.

 The rough opening width must be 1” larger than the

overall door frame width, the rough opening height

must be ½” taller then the overall height of the complete

door frame including the threshold. (WARNING) A larger

than required rough opening will weaken the door

installation and may cause personal injury, property

damage or product failure.

 The sill must be level and clean to install the door,

check the sub floor or slab foundation to make sure it is

level. DO NOT PROCEED to the next step until the

door unit can be installed onto a clean and level

surface. Scrape sand or fill the sub floor or slab

foundation with the appropriate material to insure a

clean and level sill.

 Check all framing to and make sure that the frame

work is secure and will support the weight of the

iron/steel door unit.

 Check the rough opening for plum and level using the

6 and 3 foot level. The rough opening must be plum and

level to install this door unit. Make any adjustments

needed to insure that the rough opening is plum and

level.

 WARNING to avoid the potential for electrical shock

please make sure all electrical wiring next to the door

unit is installed to code and will not allow any exposed

electrical wire, to contact the door or frame.