Instructions / Assembly

10/1/2012
7
STEP 9:
Reinstall the glass panels onto each door panel. Using a 3-in 1 oil, lightly coat the glass frame hinge pins. To
install glass panel onto the hinge pins located on the inside of the door panel. You may find it easier to hold the
door panel at a 90 degree angle and have one person align the hinge pins and at least two people lift and
lower the door panel into place. Repeat for each door panel.
To anchor the threshold to the sub floor or slab foundation remove the adjustable sill cap cover. You can
remove the cover by using a small pry bar then install the #8 3” screws through the threshold into the sub floor.
Recheck the sill for level, adjust as needed and replace the adjustable sill cap cover using the rubber mallet.
When the threshold has been levels please do not walk or place any weight onto the threshold until caulk has
fully set.
STEP 11:
STEP 12:
Mark the adjustable threshold for the location for the bottom flush bolt, located on the passive door panel.
Please make sure the passive door is fully closed when marking the center of the flush bolt pin location. Drill a
hole through only the top layer of the adjustable sill cap cover using the 5/8” drill bit. Close the passive door
and check for proper operation of the flush bolt, adjust as needed.
STEP 10:
With all the door panels and glass installed please check the door unit for proper operation and alignment.
Adjust any install screw or shims to maintain the correct operation and alignment of each door panel. Check
and retighten all install screw locations as necessary.