Instructions / Assembly

10/1/2012
8
STEP 13:
Reinstall the compression weather stripping into the jambs kerfs; the weather stripping does not need to be
glued into the frame. Ally light presser along the length of the weather stripping. If the weather stripping will not
push into the kerfs please remove and clean the kerfs and reinstall the weather stripping.
STEP 14:
To install lockset please follow the manufacturers lockset install guide provide with your hardware. The door
has been predrilled for a standard double bore lockset with two holes 2 1/8” diameter at 5 ½” center to center
and a 2 3/4” backset through the face of the door panel. The latch bore holes are 1” in diameter. Lockset must
fit a 1 ½” thick door panel.
Installing a Transom on a Installed Door Frame
 Apply two small quarter inch beads of 100% black silicon along the top of the door frame. Place the transom
frame on top of the installed door frame.
 Using the supplied quarter inch barrel nut and screws install the transom to the frame. Please place the
barrel bolt through the transom frame and the screw through the door frame.
 Place shims at each install screw location and adjust the transom frame until it is level and plum in the rough
opening.
 Apply a small quarter inch bead of 100% black silicon around the interior transom glazing bead. Install the
transom glass panel using the provide screws.