Instructions / Assembly

E - 5/16-18 NYLOCK NUT

B - .27 X 2-1/2 SOCKET WAFER A

C - 5/16-18 X 2 EYE BOLT SS

F - .307 X 2-1/2 X 3/4 S-HOOK ZN 2

COATING DETERMINED BY LOCATION OF USE

(1) Seat

Model: TXS60

Assembly Instructions

(1) Back

pg 1 of 3

(2) Sideframes

•

1/2" wrench•

6/2/2011

Layout Parts

Layout Hardware

Tools Needed

4mm Hex Key, T-Handle•

Screwdriver

ALL HARDWARE IS STAINLESS STEEL

UNLESS OTHERWISE NOTED

Qty

G - SNAP HOOK 1/4"

D - 5/16 X 3/4 OD FLAT WASHER

H - 5FT ZINC CHAIN4

A - 1/4-20 X 1-3/4 WAFER SHCS

PAGE 1
Assembly Instructions Model: TXS60 Layout Parts (1) Seat (1) Back (2) Sideframes 2 Qty Layout Hardware A - 1/4-20 X 1-3/4 WAFER SHCS 6 B - .27 X 2-1/2 SOCKET WAFER A 4 C - 5/16-18 X 2 EYE BOLT SS 4 6 2 D - 5/16 X 3/4 OD FLAT WASHER 3 E - 5/16-18 NYLOCK NUT Tools Needed 2 F - .
PAGE 2
SUGGESTION: If you can put this on a work table it will be easier to put together. Swing Assembly 1 Attach the side frames to the seat using (4) 1-3/4" SHCS bolts by fastening them from the inside. May need to lay it back to access those holes. DO NOT TIGHTEN UNTIL AFTER STEP 2 A 2 Insert back assembly into the sideframe pockets and fasten with (2) 1-3/4" SHCS into the tube at the top and (2) 2-1/2" screws thru sideframe into the pilot hole on back assembly.
PAGE 3
4 Hang the swing Tip: hanging mounts should be about 68" apart Adjust this chain for height (9ft porch max) Adjust this chain for comfort S-hook Note: once comfort is set, S-hook can be closed with tool Snap hooks Tip: Seat should measure about 18" from floor pg 3 of 3