Trex® Outdoor Furniture™ Yacht Club Swing

A
A
A
B
Swing Assembly
1
2
3
Attach the side frames to the seat using
(4) 1-3/4" SHCS bolts by fastening
them from the inside. May need to lay it back
to access those holes.
DO NOT TIGHTEN
UNTIL AFTER STEP 2
Insert back assembly into the
sideframe pockets and fasten with
(2) 1-3/4" SHCS into the tube at the top
and (2) 2-1/2" screws thru sideframe
into the pilot hole on back assembly.
Add (2) 2-1/2" screws thru the back
into pilot holes on the seat supports
The bolts installed on Step 1 can now
be tightened.
SUGGESTION: If you can put this on a work
table it will be easier to put together.
FRONT
BACK
BACK - Insert (2) eyebolt and washer thru
sideframe and tighten down on the inside
with a washer and nylock nut.
FRONT - Insert (2) eyebolts with a washer
thru front of sideframes into insert nuts
on the apron of the seat assembly.
DE
CD
DC
seat assembly apron