Installation Guide

ManualsBrandsTrex RainEscape ManualsKitchenRainEscape Deck Drainage System 2 in. x 50 ft. Double Side Elevations Butyl Tape Roll

BASIC INSTALLATION

ATTACH A STANDARD GUTTER SYSTEM (NOT

INCLUDED) TO COLLECT THE WATER FROM THE

TREX RAINESCAPE DOWNSPOUTS

FRONT VIEW

CUT A TAB ON THE TOP OF

THE GUTTER AND FOLD OVER

ATTACH TO THE BOTTOM

OF THE JOIST

ATTACH A PIECE

OF L-METAL TO

THE GUTTER, THEN

TO THE BOTTOM

OF THE JOIST

ATTACHING THE GUTTERS

INSTALLING A GUTTER SYSTEM (not included)

Before installing a gutter system perform a water

test to clean out the system and check for any leaks.

Attach a standard gutter system to collect the

water from the Trex RainEscape downspouts.

DOWNSPOUT SHOULD

EXTEND AT LEAST 1"

INTO THE GUTTER

WE SUGGEST PUTTING A 2x4 or 2x6 ACCESS PANEL TO CHECK GUTTER

WITHOUT REMOVING SOFFIT

SIDE VIEW

NOTE: Installing a clean-out trim piece will allow access to

gutter line after installation.

FOR 2" X 12" JOIST

EXTEND THE

DOWNSPOUT USING

A STANDARD

GUTTER DOWN-

SPOUT AND CUT

TO LENGTH

FOR 2 x 6 OR 2 x 8

JOIST, DOWNSPOUT

NOZZLE CAN BE CUT

TO LENGTH

SCREW GUTTER

TO DOWNSPOUT

DECKING

TROUGH

TAPE

FASCIA

SOFFIT

INSTALLATION OF FASCIA

Two suggested ways to seal fascia:

–Deck board butt against fascia (4L)

–Deck board go over fascia (4M)

2 x 4 ACCESS

PANEL

2 x 4 ACCESS

PANEL

2 x 4 ACCESS

PANEL

2 x 4 ACCESS

PANEL

DECKING

TAPE

TROUGH

SIDE VIEW

FASCIA