Installation Guide

INPUT
CABLE
T SPLITTER
LIGHT
DECK WIDTH
JOIST LENGTH
HOUSEHOUSE
10'10'
9' - 12'
INPUT
CABLE
T SPLITTER
LIGHT
10'10' 10'10'
1
0'10' 10'10'
13' - 16'
INPUT
CABLE
T SPLITTER
LIGHT
10'10' 10'10'
1
0'10' 10'10'
8'
(2.44 m)
OR LESS
9' - 12'
(2.76 -
3.65 m)
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
6 "
(15.2 cm)
1
2
Pass through
connection
Connection
from light
Dielectric
grease tube
1/4” (0.6 cm)
nail in wire
clip
Pass through
connection
SOFFIT LIGHT
MAKING CONNECTIONS
1. Install splitters to inside of framing using hardware
provided. Install a splitter at every junction where
you will run a row of lights. (9E)
2. Run wire through joist and roll up 1' - 2' (0.30 m -
0.60 m) extra wire in area the light will be installed.
Staple to the side of the joist (making sure
not to staple through the wire).
3. Cap o all unused female connections on splitters
using caps provided or weather resistant silicone. (9G)
EXAMPLE OF A 2 ROW LIGHT INSTALLATION
FOR JOISTS BETWEEN 9' AND 12' 2.76  3.65 M
EXAMPLE OF A 1 ROW LIGHT INSTALLATION
FOR JOISTS LESS THAN 8'
EXAMPLE OF A 3 ROW LIGHT INSTALLATION
FOR JOISTS BETWEEN 13' AND 16' 3.96  4.87 M
INSTALLING THE LIGHTS
» Install ceiling of your choice. Make sure to
remember where wire end is located.
» Mark where the light is to be installed and use
4-5/8" or 120 mm hole saw to bore hole,
(a jig saw can be used instead of a hole saw).
» Reach up through the hole and pull out wire end
and attach to light.
» Fold orange springs up and push light into opening.
The springs will fold down and hold light in place.
» If using directional feature, spin light so it
shines on desired area.
9B
9E
9F
9G
9C
9D
12
13' - 16'
(3.96 -
4.87 m)
BASIC INSTALLATION