Installation Guide

19
WIRE
TAPE PATCH
WIRE
»
Fish wire up through the gap between the trough
and downspout. (19D)
»
Cut hole to fish wire going up through side
of joists. Caulk around wire piece and tape over
wire. (19C)
19E
19C
19D
21. DECK STEP
»
(1) Install the downspouts and troughs on the
lower deck.
»
(2) Install trough material starting from the lower
deck working your way up the stair tread to the upper
deck. Overlap the trough material from step 1.
»
(3) Install the trough and downspouts on the
top deck.
»
(4) After step 3 is complete, finish the installation
of the troughs and downspouts on the upper deck.
»
Tape over all exposed seams and where deck
screws will penetrate.
20. INSTALLING LOW PROFILE CAN LIGHTS
»
When installing low profile can lights below the
trough, make sure the light does not come in
contact with the trough material. (20)
ON THE LOWER DECK, ADD A
BEAD OF CAULK WHERE THE
UPPER DECK FRAMING MEETS
THE LOWER DECK FRAMING
BEFORE INSTALLING THE FIRST TROUGH ON
THE UPPER DECK, ADD A BEAD OF CAULK
ON TOP OF THE TROUGH MATERIAL THAT
EXTENDS THE LENGTH OF THE DECK
21
TAPE ALL
EXPOSED
SEAMS
WHERE
DECK
PENETRATION
WILL OCCUR
2
1
3
ON THE UPPER DECK ADD A BEAD OF
CAULK ON TOP OF THE FIRST JOIST
17
TROUGH SHOULD NOT MAKE CONTACT
WITH THE RECESSED CAN LIGHT
MAXIMUM DEPTH FOR TROUGH IS 4"
4"
TROUGH
SIDE VIEW
DECKING
JOIST
JOIST
OPTION: ADD A PIECE OF CEMENT SIDING OR
DRYWALL TO DEFLECT THE HEAT FROM THE LIGHT
20
#2 THROUGH OPENING WHERE
DOWNSPOUTS MEET TROUGH
MODIFICATIONS & SPECIAL CASES