Installation Guide

76
SIGNATURE RAILING
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
POST
SLEEVES
WILL
NEED TO
BE CUT
TREX SIGNATURE
RAILING CONFIGURATIONS
Cutting posts/post sleeves is NOT required.
A. Signature post, pressure-treated post or Trex Post Mounts* with Trex Transcend post
sleeves, or Trex Joist Mount Posts*.
B. Signature top rail
C. Signature bottom rail
D. Signature balusters
See page 78 for “How to Install Standard Railing”.
*NOTE: See specifi c installation instructions for attachment of Trex post mounts or Trex
Joist Mount Posts prior to installing any railing.
Cutting posts/post sleeves is NOT required.
A. Pressure-Treated post with Trex Transcend post sleeve
NOTE: » Only for use with 4" x 4" (102 mm x 102 mm) or 6" x 6" (152 mm x 152 mm)
post sleeve
» Trex Signature Posts, Trex Post Mounts or Joist Mount Posts cannot be
used with Signature Traditional design
B. 2" x 4" (51 mm x 102 mm) lateral top rail
C. Signature top rail
D. Signature bottom rail
E. Signature balusters
F. Signature Cocktail Rail Bracket**
See page 88 for “How to Install Signature Traditional Railing”.
Post sleeves WILL NEED TO BE CUT.
A. Pressure-treated post with Trex Transcend post sleeve
NOTE: » Only for use with 4" x 4" (102 mm x 102 mm) post sleeve.
» Trex Signature Posts, Trex Post Mounts or Joist Mount
Posts cannot be used with Signature® Cocktail design.
B. Deck board top rail. NOTE: Contour and Escapes cannot be used.
C. Signature top rail
D. Signature bottom rail
E. Signature balusters
F. Signature Cocktail Rail Bracket**
See page 87 for “How to Install Signature Cocktail Railing”.
A
B
C
D
A
B
D
C
E
F
A
B
D
C
E
F
Standard
Cocktail
Traditional
** Signature Cocktail Rail brackets (sold separately) are for use with either Signature Traditional or Signature Cocktail designs. For a 6' section, use 4
brackets and screws provided, for 8' section, use 5 brackets and screws provided.