Installation Guide

99
SIGNATURE RAILING
ATTACHING STAIR BRACKETS (FIXED STAIR, STAIR SWIVEL, AND
COMPOUND SWIVEL) TO SIGNATURE POSTS AND PRESSURE-
TREATED POST AND POST SLEEVES/
CONTINUED
TREX SIGNATURE
Cutting Top Stair Rail and Rail Insert
Option 3:
For Stair-Crossover-Post-to-Stair-Crossover-Post
Configuration
12a. Cut each end of the top stair rail along with rail
insert on the mark line to allow for fi t into the
crossover post bracket on each side.
Cutting Top Stair Rail Cover, and Attachment of
Top Stair Rail Cover
13. Mark and cut top rail
cover same length as
top rail for all top rail
confi gurations.
14. Attach “crowned” upper stair rail cover to upper
stair rail by aligning cover on one side of rail. Then
starting from one end of stair rail, snap cover onto
opposing slot working down length of stair rail. A
rubber mallet may facilitate the fastening using
GENTLE tapping.
Installing Balusters into Bottom Stair Rail
15. Place balusters into
holes in lower stair rail
by snapping fully into
place. In some cases,
a rubber mallet may
facilitate the fastening
using GENTLE
tapping.
1
14
3
2
15
13
12a
KEY
Mark
Cut
KEY
Top stair rail
Crossover post
Crossover post