Installation Guide

113
SIGNATURE RAILING
HOW TO INSTALL FOOT BLOCKS – PANELS
TREX SIGNATURE
Attachment of Foot Block (Required ONLY for All
Clear Span Applications Over 6
' [1.83 m])
1. To ensure correct location, place foot block under
center of bottom rail. Mark to provide placement
location of base.
2. Place base (smaller
side facing down)
on decking surface.
Attach base of foot
block using one screw
at an angle through
base and into decking.
NOTE: Pre-drilling is recommended (1/8" [33 mm]
drill bit) for attachment of base.
3. After attached, use a
rubber mallet along
with scrap piece of
wood to tap foot block
until it locks into place.
1
2
1
2
1
3