Installation Guide

20
LIGHTING
8. Ensure that lights are
all working with all
wiring attached prior to
burying any wire.
No more than 1"–3"
(25 mm–76 mm) is
required.
HOW TO INSTALL TREX LANDSCAPELIGHTING/CONTINUED
(TREX SPOTLIGHT)
1˝–3˝
(25–76 mm)
8
A. ALWAYS keep antenna
fully extended for max
range.
B. Up/Down arrows
gradually dim or brighten
lighting.
C. On/Off button cycles
lights ON/OFF.
D. Mode button cycles
through 3 preset
dimming levels: High,
Medium, Low, and Off.
NOTE: First make sure the
red light is illuminating on
the remote. If there is no red
light and the product is new,
contact 1-800 BUY-TREX
for a replacement. If the
product is not new, the A27
battery is replaceable.
1. Install dimmer per
instructions and make
sure lights are On and
working properly.
2. Unplug the transformer
to turn lights Off.
3. Press and hold both the up and down arrow on the
dimmer remote simultaneously.
4. With the dimmer arrow buttons held down, plug the
transformer back in. The lights should blink once to
confi rm programming.
5. Release the up and down arrows on the remote and
test remote to confi rm proper operation.
HOW TO PROGRAM DIMMER REMOTE
2
3
4
1
2
A
B
C
D