Installation Guide

97
SIGNATURE RAILING
Attaching Stair Crossover Swivel Bracket to
Post
6. Insert stair crossover swivel bracket into post.
NOTE: Keep the bracket cover on when inserting this
into post, this will cover the screw attachment area.
7. Determine location/height of the stair crossover
swivel bracket by aligning the angle of this with the
fi xed brackets (or compound swivel brackets) already
installed.
8. Once location/height is determined, center and pre-
drill two holes (using a drill bit slightly smaller than
that of self-tapping screw diameter) on opposite sides
of post, approx. 1/4" from top of post. Drill through
the post and into the stair crossover swivel bracket on
each side.
9. Attach stair crossover swivel bracket to post with two
self-tapping screws (provided). Slide cover over post
to hide screws.
ATTACHING STAIR BRACKETS (FIXED STAIR, STAIR SWIVEL, AND
COMPOUND SWIVEL) TO SIGNATURE POSTS AND PRESSURE-
TREATED POST AND POST SLEEVES/
CONTINUED
TREX SIGNATURE
Bracket
cover
6
7
X°
8
1/4"
(0.6 cm)
1/4"
(0.6 cm)
9
1
2