Installation Guide

122
SELECT RAILING
HOW TO INSTALL TREX SELECT STAIR RAILING/CONTINUED
TREX SELECT
If Attaching Original Foot Block to Bottom Rail
4a. For stair applications, cut the section of foot block at
an angle to match rail. Refer to foot block instructions
for specifi c information on how to do this.
4b. Invert bottom rail. Center foot block on bottom
rail and attach at marked position per Original foot
block instructions. DO NOT extend foot block.
If Attaching New Foot Block to Bottom Stair Rail
4c. Invert the bottom stair
rail. Center and drill a
hole using a 3/16" drill
bit. This will be location
for foot block (to be
installed last).
Attachment of
Brackets to Railings
5a. Check fi t for both top
and bottom railings in
designated positions
for location onto posts.
Remove railings.
Upper Stair Post
Locations
5b. Snap the top stair
adaptor bracket
(labeled TOP) to the
standard bracket.
Repeat for remaining
bracket.
Upper Stair Post Locations
5c. On the TOP RAIL, attach the assembled top stair
bracket to the side with baluster holes. On the
BOTTOM RAIL, attach the assembled top stair
bracket to the OPPOSITE SIDE of the baluster
holes. Attach both brackets using three #8-18 x 1"
self-drilling screws (provided).
Lower Stair Post
Locations
5d. Snap the bottom
stair adaptor bracket
(labeled BOTTOM) to
the standard bracket.
Repeat for remaining
bracket.
5e. On the TOP RAIL, attach the assembled bottom
stair bracket to the side with baluster holes. On
the BOTTOM RAIL, attach the assembled bottom
stair bracket to the OPPOSITE SIDE of the baluster
holes. Attach both brackets using three #8-18 x 1"
self-drilling screws (provided).
4a
1
4b
2
4c
5a
5d
1
1
5c
Top Rail Bottom RailBottom Rail
22
5b
1
1
5e
Top RailTop Rail Bottom RailBottom Rail
22