Installation Guide

24
LIGHTING
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
10. Slide light cover down over backing plate, adjusting
mounting screws as necessary to achieve a tight fi t.
11. Turn post over and carefully fi sh wire through hole
created in Step 3 to underside of the deck. Ensure
exit point of wire under blocking will not be pinched
by ALPOSTHWDECK plate.
12. Mount post per instructions.
NOTE: If connecting a Signature post cap light as well,
a 3-way adapter and extra 5' male-to-male wire (not
provided) can be used inside the post so that only one
wire must be run through the hole in the base of the post
(and post blocking). This is optional.
6. Turn post upside down and fi sh 5' male-to-male wire
(provided) through hole in baseplate.
7a. If connecting a Wedge Deck Rail Light only, pull wire
through hole.
TIP: Insert a zip-tie loop (or small grabber tool) through
9/16" (14 mm) hole. Fish wire through loop in zip-tie.
Pull wire through hole with zip-tie.
7b. If connecting a
Signature post cap light
as well, and using the
3-way splitter (see note
after Step 12), simply
run one wire through the
hole created in Step 5
to the top of the post.
8. Connect male connector to female connector on
light housing.
9. Place light and attach backing plate to post with
three screws (provided).
6
8
10
3
7a
1
2
7b
5' Male-to-Male Wire
(from Post Cap)
5' Male-to-Male Wire
(from Post Lamp)
5' Male-to-Male Wire
(from Baseplate hole)
3-Way Splitter
1
9
2
11
HOW TO INSTALL TREX WEDGE DECK RAIL LIGHT/CONTINUED