Installation Guide

113
TREX
®
SIGNATURE™ RAILING
IMPORTANT NOTE:
» Only for use with pressure-treated 4 x 4 post (3.5"
nominal square) and 4" x 4" (102 mm x 102 mm) or
6" x 6" post sleeve. Trex
®
Signature™ Posts, Trex
Post Mounts or Joist Mount Posts cannot be used
with Trex
®
Signature™ Traditional railing.
Installing Standard Trex
®
Signature™ Stair Posts, or
Pressure-treated Post
1. See instructions on page 99.
Installing Lower Stair Brackets
2. See instructions on page 100 for fixed stair brackets
or page 104 for swivel stair brackets.
How to Measure Bottom Stair Railings
3. See instructions on page 100 for fixed stair brackets
or page 105 for swivel stair brackets.
Cutting Bottom Stair Rail, Bottom Stair Rail Cover
4. See instructions on page 100 for fixed stair brackets
or page 104 for swivel stair brackets.
Attachment of Bottom Stair Rail Cover and Bottom
Stair Rail
5. See instructions on page 101 for fixed stair brackets
or page 105 for swivel stair brackets.
Installing Upper Stair Brackets and Measuring Upper
Rail
6. See instructions on pages 101 for fixed stair brackets
or page 105 for swivel stair brackets.
Cutting Top Stair Rail, Rail Insert and Cover
7. See instructions on page 102 for fixed stair brackets
or page 106 for swivel stair brackets.
Installing Balusters into Bottom Stair Rail
8. See instructions on page 102 for fixed stair
brackets or page 106 for swivel stair brackets.
Attaching Upper Stair Rails
9. See instructions on page 103 for fixed stair brackets
or page 106 for swivel stair brackets.
Attaching 2"x 4" to Top Rail
10. Place 2" x 4" (51 mm x 102 mm) beside top rail. Mark
and cut (both ends need to be cut on an angle for
proper fit).
HOW TO INSTALL TREX
®
SIGNATURE™ TRADITIONAL STAIR RAILING
TREX
®
SIGNATURE™
10