Installation Guide

123

TREX

SIGNATURE™ RAILING

HOW TO INSTALL FOOT BLOCKS – PANELS

TREX

SIGNATURE™

Attachment of Foot Block (Required ONLY for All

Clear Span Applications Over 6

[1.83 m])

1. To ensure correct location, place foot block under

center of bottom rail. Mark to provide placement

location of base.

2. Place base (smaller

side facing down) on

decking surface. Attach

base of foot block

using one screw at an

angle through base and

into decking.

NOTE: Pre-drilling is recommended (1/8" [33 mm] drill

bit) for attachment of base.

3. After attached, use a

rubber mallet along

with scrap piece of

wood to tap foot block

until it locks into place.