Installation Guide

18
LIGHTING
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
A. ALWAYS keep antenna
fully extended for
maximum range.
B. Up/Down arrows
gradually dim or brighten
lighting.
C. On/Off button cycles
lights ON/OFF.
D. Mode button cycles
through 3 preset
dimming levels: High,
Medium, Low, and Off.
NOTE: First, make sure the
red light is illuminated on
the remote. If there is no
red light and the product is
new, contact 1-800 BUY-
TREX for a replacement. If
the product is not new, the
A27 battery is replaceable.
1. Install dimmer per
instructions and make
sure lights are ON and
working properly.
2. Unplug the transformer
to turn lights OFF.
3. Press and hold both the up and down arrow on the
dimmer remote simultaneously.
4. With the dimmer arrow buttons held down, plug the
transformer back in. The lights should blink once to
confirm programming.
5. Release the up and down arrows on the remote and
test remote to confirm proper operation.
HOW TO PROGRAM DIMMER REMOTE
2
3
4
1
2
A
B
C
D
HOW TO INSTALL TREX
®
SIGNATURE™ CAP LIGHT
(CAN ONLY BE USED ON TREX
®
SIGNATURE™ POSTS)
PARTS
A
Post Cap Light
(includes 5ft male-to-male wire)
9/16" x 6" or Longer
(14 mm x 152 mm)
TOOLS NEEDED
» 5ft, 10ft, 20ft, 40ft, and 60ft connection/extension
wires sold separately (these are male-to-male
connection wires).