Installation Guide

21
LIGHTING
10. Slide light cover down over backing plate, adjusting
mounting screws as necessary to achieve a tight fit.
11. Turn post over and carefully fish wire through hole
created in Step 3 to underside of the deck. Ensure
exit point of wire under blocking will not be pinched
by ALPOSTHWDECK plate.
12. Mount post per instructions.
NOTE: If connecting a Trex
®
Signature™ post cap light
as well, a 3-way adapter and extra 5' male-to-male wire
(not provided) can be used inside the post so that only
one wire must be run through the hole in the base of the
post (and post blocking). This is optional.
6. Turn post upside down and fish 5' male-to-male wire
(provided) through hole in baseplate.
7a.If connecting a Wedge Deck Rail Light only, pull wire
through hole.
TIP: Insert a zip-tie loop (or small grabber tool)
through 9/16" (14 mm) hole. Fish wire through
loop in zip-tie. Pull wire through hole with zip-tie.
7b. If connecting a Trex
®
Signature™ post cap
light as well, and using
the 3-way splitter (see
note after Step 12),
simply run one wire
through the hole
created in Step 5
to the top of the post.
8. Connect male connector to female connector on
light housing.
9. Place light and attach backing plate to post with
three screws (provided).
6
8
10
3
7a
1
2
7b
5' Male-to-Male Wire
(from Post Cap)
5' Male-to-Male Wire
(from Post Lamp)
5' Male-to-Male Wire
(from Baseplate hole)
3-Way Splitter
1
9
2
11
HOW TO INSTALL TREX WEDGE DECK RAIL LIGHT
(CAN ONLY BE USED ON TREX
®
SIGNATURE™ POSTS)