Installation Guide

HOW TO INSTALL DECKING

LOCATION AND INSTALLATION OF IRC-APPROVED POST MOUNTS – CONCRETE

IMPORTANT NOTES:

» INSTALLATION SHOWN HERE IS FOR IRC

APPROVED APPLICATIONS ONLY.

» MAKE SURE CONCRETE IS LEVEL BEFORE INSTALLING POSTS.

» ALWAYS REFER TO YOUR LOCAL BUILDING CODE OFFICIAL

PRIOR TO INSTALLING ANY RAILING SYSTEM TO ENSURE ALL

CODE AND SAFETY REQUIREMENTS ARE MET. TREX CANNOT BE

HELD RESPONSIBLE FOR IMPROPER OR NON-RECOMMENDED

INSTALLATIONS.

CANNOT BE USED WITH TREX TRANSCEND COCKTAIL RAILING.

» See page 54

for sku information.

TOOLS NEEDED

Hammer

Drill and/or screw gun

3/8" (10 mm) drill bit for concrete

PARTS

» (1) Post mount

» (2) Guide blocks

» (18) #8-15 x 1-1/4" (32 mm)

Screws

» (2) 10 x 1" (25 mm)

Self-tapping screws

SKU ALPOSTHWCONC

(this SKU SOLD SEPARATELY)

» (4) 3/8" x 3-3/4"

(10 mm x 95 mm)

Expansion anchor

» (4) Flat washers

» (4) Hex nuts

Pre-drill Holes

1. Using post as a template, mark locations of the four

holes and drill into concrete at least 2-5/8" (66.7

mm) using a 3/8" (10 mm) masonry bit.

NOTE: You can either set drill bit to correct depth on

drill or mark drill bit with tape at required dimension to

ensure all holes are drilled at the correct depth.

2. Clean out holes to remove all concrete dust.

3/8"

(10 mm)