Installation Guide

HOW TO INSTALL DECKING

HOW TO INSTALL POST MOUNTS ON CONCRETE/CONTINUED

TOOLS NEEDED

Position Leveling Plates

1. Using leveling plate as a template, mark locations

of the four holes and drill into concrete at least

3-1/2" (8.9 cm) using a 1/4" (0.6 cm) masonry bit.

Install Leveling Bolts and Level Post Mount

2a. Partially thread four 5/16" x 1" (0.8 cm x 2.5 cm)

hex (leveling) bolts in post mount. Place leveling

plate on concrete holes aligned.

2b. Place post mount on leveling plate and adjust

5/16" x 1" (0.8 cm x 2.5 cm) hex (leveling) bolts to

plumb.

Install Mounting Bolts

3. Secure post mount with four concrete bolts and

washers.

NOTE: Torque recommended is 5 - 10 ft. lbs.

Install Guide Blocks

4. Place the two guide blocks on post mount and

secure with self-tapping screws (provided).

Install Railing System of Choice

NOTES: If installing a Trex® railing system:

» Mark screw placement on post sleeve for the

rail support brackets (RSBs).

» Pre-drill screw holes through post sleeve and

aluminum guide blocks with a 1/8" (0.3 cm) drill bit.

» Attach RSBs using 1-1/2" (3.8 cm) . screws

(provided) for 4" x 4" (10.2 cm x 10.2 cm) Trex post

sleeves.

» Attach RSBs using 2" (5.1 cm) screws (provided)

for 6" x 6" (15.2 cm x 15.2 cm) Trex post sleeves.

1/4"

(0.6 cm)