Installation Guide

72
TRANSCEND RAILING
Attaching Foot Block to Bottom Rail
4. Center foot block in Universal rail channel or on
underside of Beveled rail at center and attach
collapsed foot block (DO NOT extend foot block) to
rail using 2" (5.1 cm) screw (provided).
Installing Bottom Rail with Foot Block
5. Secure rail on RSBs and extend foot block to seat on
foot block base plate.
Securing Foot Block
6. With foot block fully
seated on base plate,
secure with two 3/4" (1.9
cm) retaining screws
(provided). Install one on
each side of foot block
1-1/2" (3.8 cm) from
bottom of base. Place
screw plugs.
HOW TO INSTALL CROWN,
UNIVERSAL, AND BEVELED FOOT
BLOCK FOR STAIR RAILING TREX
TRANSCEND
®
Cutting Foot Block
7a. Dismantle foot block
into two sections – this
can be done by fully
extending the upper
beam and continuing to
pull this through which
will separate the foot
block into two sections.
7b. For stair applications, cut top section of foot block
at an angle to match rail.
7c. Re-assemble the foot block by pushing the upper
beam through the underside of the base of the foot
block and allowing this to catch/snap into position.
DO NOT fully extend at this time.
Attaching Foot Block
to Bottom Stair Rail
8. Invert bottom stair rail.
Center foot block on
bottom rail and attach.
DO NOT extend foot
block.
Complete Stair Rails
Installation
9. Install foot blocks
prior to installing
lower rail per previous
instructions. For stair
application, cut top
section of foot block at
an angle to match rail,
pre-drill, and fasten.
Install top and bottom
railings, balusters,
and baluster spacers
according to previous instructions based on the
style railing that is installed.
1
1
5
3
2
1-1/2"
(3.8 cm)
1-1/2"
(3.8 cm)
6
1
2
7a
7b
7c
1
8
2
1
4
2
HOW TO INSTALL UNIVERSAL AND BEVELED RAILING FOOT
BLOCKS/CONTINUED
TREX TRANSCEND
®
9