Installation Guide

SELECT RAILING

HOW TO INSTALL TREX

SELECT™ RAILING/CONTINUED

TREX SELECT™

5c. Attach top rail to balusters, feeding each baluster

into required slots. Start on one end and work

towards the other.

5d. To help temporarily secure the railing section

together, place a ratchet strap around the top

and bottom rail and tighten until snug. DO NOT

OVERTIGHTEN AS YOU CAN BEND THE RAILING.

Installing Railing Section to Posts

6a. Using scrap material (i.e. 2 x 4s, decking boards, etc.)

cut at least three support blocks at 3-3/4" (9.5 cm)

in height. Place one each on decking surface beside

each post and one near center of span.

6b. Slide brackets on each end of both top and

bottom railing.

6c. Lift secured railing

section up, and

CENTER this section

in between the

spanned posts on pre-

positioned support

blocks.

NOTE: To help stabilize

railing section use a

quick-grip clamp (or other type of clamp) and clamp the

ﬁrst baluster to post sleeve. (DO NOT OVERTIGHTEN

CLAMP.)

6d. Install bottom bracket (both sides) to post using

four #8-10 x 2" (5.1 cm) screws per bracket

(provided).

6e. Install top bracket (both sides) to post using four

#8-10 x 2" (5.1 cm) screws per bracket (provided).

6f. Install bottom bracket (both sides) to railing using

four #10 x 1" screws per bracket (provided).

6g. Install top bracket (both sides) to railing using four

#10 x 1" screws per bracket (provided).

Attaching Bracket Covers and Post Caps

7a. Snap bracket covers over each bracket.

7b. Secure post caps with silicone or PVC adhesive.

NOTE: Clean-up any excess adhesive before drying.

6d 6e

3-3/4"

(9.5 cm)

6f 6g