Installation Guide

SELECT RAILING

Attaching Footblock to Bottom Railing

» REFER TO PAGE 80 FOR DETAILED

INSTRUCTIONS ON INSTALLATION OF FOOT

BLOCK (BASIC STEPS ARE SHOWN BELOW).

4a. For stair applications, cut the section of foot

block at an angle to match rail. Refer to foot block

instructions for speciﬁc information on how to

do this.

4b. Invert bottom rail. Center foot block on bottom rail

and attach. DO NOT extend foot block.

Attachment of Bottom Rail to Post

5a. Slide bottom stair brackets on bottom rail (tab on

bracket should be facing up) on each side.

5b. Assemble a few of the balusters into the bottom

and top railings (make sure balusters are setting

at 90 degrees) and set this on scrap material

clearing the stair treads to determine where

bracket locations need to be. Measure to make

sure that bottom railing will clear the stair treads

as well as top railing will be aligned with horizontal

railing (remember in most cases, a post and

post sleeve longer than 39" (99.1 cm) will be

needed on the lower section of stair rail to

accommodate stair angle).

5c. After locating

appropriate position

for bottom rail remove

top rail and balusters

and attach bottom

stair bracket (both

sides) to post using

four #8-10 x 2"

(5.1 cm) screws per

bracket (provided).

Install Balusters

6. Slide balusters into

bottom rail.

HOW TO INSTALL TREX

SELECT™ STAIR RAILING/CONTINUED

TREX SELECT™